Save. Share. Connect.
Friday, September 22, 2017
VOLUME -27 NUMBER 10
Publication Date: 10/1/2012
Front Page News
People in the News
Electronic Mfg. Services
Electronic Mfg. Products
Special Features: Components and Dist.
electronica Product Preview
October 2012 Issue
Add Message Board
Ametek Intros High Bandwidth Solar Array Simulators
San Diego, CA — Ametek Programmable Power has expanded its Elgar TerraSAS
line with the addition of the ETS Series Standalone Photovoltaic (PV) Simulator. The new Series includes three models for testing PV inverters across a wide spectrum of applications: ETS 80 to test micro-inverters or DC optimizers up to 80VDC Voc; ETS 600 for testing string inverters that contain transformer isolation up to 600VDC Voc; and ETS 1000 for non-isolated string inverters up to 1000VDC Voc.
The ETS 600 and ETS 1000 are 3U rack units, while the ETS 80 comes in a 1U package. The ETS 80 also is cost effective, being 30 to 40 percent less costly than units with comparable output specifications.
For microgrids, energy storage, and inverter test applications, TerraSAS PV Simulators are specifically designed to emulate the dynamic electrical behavior of a terrestrial PV solar array. They offer low output capacitance and high closed loop bandwidth to keep up with the advanced Maximum Power Point Tracking (MPPT) algorithms used in today's grid-tied inverters.
All Elgar ETS Series units are high-performance solutions packaged in a small form factor that combine an agile power supply, an innovative I-V curve generator, output isolation and Graphical User Interface (GUI) in a single, standalone unit.
The Elgar TerraSAS and ETS Series PV simulators are based on high-speed versions of Elgar power supplies, where output capacitors, advanced DSP signal processing techniques, and other speed-limiting components have been adjusted to create a proprietary solution more advanced than any other solar array simulator on the market. This combination of hardware, software, and firmware allows the TerraSAS to simulate test protocols or combinations of events that are found in a real-world solar installation.
Under some conditions, traditional DC power sources using Insulated-Gate Bipolar Transistors (IGBT) technology do not meet MPPT response speed requirements. Elgar ETS Series units use Power MOSFETs, which typically switch ten times as fast as the most recent IGBTs. Higher switching frequency translates to smaller output capacitors and inductors — which is the key to a successful high speed power supply design.
Contact: Ametek Programmable Power, Inc., 9250 Brown Deer Rd, San Diego, CA 92121
800-733-5427 or 858-450-0085 fax: 858-458-0267 E-mail: email@example.com Web:
© 2015 USTECH. All Rights Reserved. |
Contact Us: 610-783-6100 | firstname.lastname@example.org
powered by GIM