Save. Share. Connect.
Saturday, May 28, 2016
VOLUME - NUMBER
HOME / CURRENT ISSUE
Electronic Mfg. Products
Add Message Board
Multi-Seals Intros Nano-Forms Preforms
Manchester, CT — Multi-Seals Inc. is introducing Nano-forms
epoxy preforms to provide precision seals on microelectronics. With preforms as small as 0.035-in. (0.89mm) outside diameter and 0.011-in. (0.28mm) inside diameter, Nano-forms allow highly repeatable placement of minute amounts of epoxy with precision that is unattainable with traditional dispensing methods.
With dimensional tolerances as close as ±0.0005-in. (0.013mm) for critical applications, Nano-forms can control epoxy volume to within 0.00002cc for a typical configuration. Exceptional repeatability is further promoted with closely controlled pre-mixed ratios of resin to catalyst. In addition, Nano-forms are not affected by pot life, so epoxy viscosity is consistent from beginning to end of every production batch.
This combination of precision and consistency make Nano-forms suitable for sealing fiber-optics and subminiature switches, capacitors, diodes, LEDs, and other microminiaturized components. Like other Uni-forms epoxy preforms, Nano-forms are pre-shaped, one-part resins that are solid at room temperature. When heated, they melt and cure, forming a consistent seal that protects components from dust, moisture, oil, flux, solvents, conformal coatings, and other contaminants. Multiple epoxy systems are available to meet diverse application requirements.
Contact: Multi-Seals Inc., 540 North Main Street, Manchester, CT 06042
860-643-7188 fax: 860-643-5669 E-mail: email@example.com Web:
© 2015 USTECH. All Rights Reserved. |
Contact Us: 610-783-6100 | firstname.lastname@example.org
powered by GIM